Author: kpmartin

Not News: Our mould & deckle sets in a major movie

This isn’t really news because it occurred in 2009, but I’m finally stripping old “news” from our home page and I thought I should keep this in the record somewhere. The (then-)recently-released film The Time Traveler’s Wife, based on a

Upcoming Summer Papermaking Workshops

We’ve (finally) selected a couple of dates for our Introductory Papermaking workshop this summer. The first, admittedly on very short notice, is on Saturday June 24th, and the other is about a month later on Saturday July 22nd. Both workshops

Monotype Composition Caster Pot Temperature Controller

Over the past few months, I’ve had to replace the old Partlow temperature controller on the pot of my Monotype Composition Caster. On my caster the old mechanical controller has failed; each time I ran the caster I found that

2023 ATF Conference Photos

The 2023 American Typecasting Fellowship conference took place over the weekend of April 30th/May 1st 2023 in the area around Portland, Maine.

An Excellent Film for English Monotype Operators

That is, for people who operate an English Monotype Composition Caster (as opposed to the American Lanston Monotype machine). Even more specifically, given the mix of English and American equipment now in use, for users of English composition moulds. There

Progress on the Mackenzie Printery’s Linotype (Lower Reed Comb)

This is yet another repair I had to make on the Linotype at the MacKenzie Printery and Newspaper Museum. The keyboard assembly has a row of 91 short pushrods, known as the Lower Reeds, which push up when a key

Tagged with:

Linotype Knife Block R&R

The knife block on the Linotype at the Mackenzie Printery Museum was pretty much impossible to adjust due to dried out lubricant. This block controls the position of the right knife which trims the thickness of the cast slug to

Tagged with:

Progress on the Mackenzie Printery’s Linotype (Broken Upper Reed)

One of the tasks I had in getting the Linotype at the Mackenzie Printery and Newspaper Museum working was to repair one of the keyboard reeds which I had broken (I blame the service manual for failing to warn of

Tagged with:

Monotype Repairs: An Enclosure for a New Pot Temperature Controller

While using my Monotype Composition Caster recently, I’ve noticed that the pot temperature has been drifting. On several occasions I’ve found it to be quite a bit hotter than the setpoint, to the point where I had to select a

American Typecasting Fellowship Meeting this April

After one cancellation and one virtual meeting both due to the COVID-19 pandemic, the American Typecasting Fellowship (ATF) will be holding its first in-person conference since the August 2018 conference hosted by M&H Type in San Francisco. This year’s event

Tagged with:
Top