A Calligraphy Set We’ve Always had Trouble With

IMG_8382We’ve had this calligraphy set in our store for years, but we’ve never had any success using it. The problem we run into is that the ink does not wet the nibs and flow out properly; instead whatever ink gets on the nib just beads up in drops. This seems to happen no matter what ink we’ve tried (although I must admit this is definitely not a wide range, and in particular does not include oil-based inks).

The set includes several pen nibs, a handle, brush, pencil, black ink, and three colours of watercolour paint. Along with these tools and materials, there is a book of projects and a separate book on technique. The latter mentions the problem of the ink not wetting the nibs and suggests that new nibs must be thoroughly cleaned with soap. We’ve tried this to no avail as well. I have to wonder if these particular nibs are coated with some sort of silicone, which would be resistant to soap.

One calligraphy book I recently leafed through at the local library suggested scorching new nibs in a candle flame to remove their water-repellant coating. This struck me as a poor solution, since too much heat would cause the steel in the nibs to lose their temper and thus their springiness.

Tools and supplies included in the set

Tools and supplies included in the set

The four nibs (l-r): #5 roundhand, #3 roundhand, #5 poster, and copperplate

The four nibs (l-r): #5 roundhand, #3 roundhand, 8mm poster, and copperplate. The #5 has an ink reservoir clipped onto it which can be transferred to the other roundhand nib.

The nibs appear to be gold-plated, but rust on the shank of the #5 roundhand nib belies that fact that the underlying metal is plain (not stainless) steel. I don’t want to try the candle trick, but I would really like to get these working properly. I have a few solvents I can try to remove the coating, but if any of you have specific suggestions as to what to try…

I found one YouTube video that also suggests the scorching technique, but also rubbing alcohol, stabbing the nib into a raw potato repeatedly, and cleaning with toothpaste and an old toothbrush. Any of these might be viable on a copperplate nib, but the roundhand and poster nibs have internal surfaces that pretty much preclude any sort of mechanical cleaning. There is a big fat fingerprint clearly visible on the poster nib so clearly cleaning is a regular chore!

Posted in Calligraphy, Kevin
2 comments on “A Calligraphy Set We’ve Always had Trouble With
  1. Carol says:

    Toothpaste. Put a tiny bit of toothpaste (not the gel type) on a piece of paper towel n’ carefully rub in a circular motion all over the nib. throughly, rinse toothpaste off the nib. Before using the nib, apply a small amount of gum Arabic to a piece of paper towel n’ carefully rub all over the nib.
    You should be good to go after this.
    If it doesn’t work try using a using toothbrush to apply the toothpaste. Or just use the toothbrush from the get go.
    Good luck!

  2. kpmartin says:

    I considered the toothpaste idea. It seemed for me that it would work fine for nibs with simple shapes, but it would not get into internal surfaces of nibs with reservoirs. Also it wasn’t clear how well it would clean out the slit, a place where it is critical for the ink to wet the metal.

    I ended up using the flame technique, passing the nib through a lighter flame until is was sooty, then wiping off the soot. That seemed to work, and now the nibs hold ink properly.

Leave a Reply

Your email address will not be published. Required fields are marked *